|
|
 |
|
| 1. |
Are the Redline Toolholders balanced? |
| |
Yes. The End Mill Holders and ER Collet Chucks are balanced to G2.5@18,000
RPM. |
|
| 2. |
Are all Redline Products made in the U.S.A.? |
| |
Yes. |
|
| 3. |
Can I use the Redline Thread Mills to do OD threads? |
| |
No. Redline thread mills are for internal threads only. |
|
| 4. |
How are Redline cutting tools shipped from the factory? |
| |
All cutting tools are shipped via UPS blue at UPS Ground rates from the factory. |
|
| 5. |
Some of the Redline carbide tools are AlTin coated. What is the difference between TiAln and AlTin coatings? |
| |
AlTin coating has a higher aluminum content than TiAln coating. Some benefits of AlTin coating are high toughness, hardness and heat resistance. This improves cutting tool performance in materials 40 HRC and higher. |
|
| 6. |
Where can I locate technical information about Redline products? |
| |
In the Redline catalog on pages 235-238.
Thread mill speeds & feeds are located on page 49. You can also find technical information on our website. |
|
|